User`s guide

Operation
92
• set and view current configuration parameters (Status tab)
• run analyses using one or multiple methods (Run tab)
• view instrument information (Log tab)
The Status tab provides information on the current ATD/TD
settings. You can also make changes to the ATD/TD parameters
directly from the Status screen. Changes you make on the Status tab
will take effect immediately unless an analysis is in progress. The
ability to edit parameters will be disabled until the analysis is
complete. You can use the Status tab to create and test new methods.
The Run tab allows you to create a sequence of methods to be used
on a series of samples. You create a sequence by selecting a range of
tubes and then specifying a method by which these tubes will be
analyzed. If you are using the PC Control Software, you can save
sequences and recall them as required. When a sequence is recalled
you must ensure that all the methods, called by the sequence, are
valid.
The Log tab allows you to view the analysis history of the TD. An
entry will be made whenever a tube is analyzed. Entries will also be
made if an error occurs.