Product guide

www.atcom.cn 5
Chapter 2 Hardware Introduction
GX01: GSM module, one GX01 supports one GSM channel.
AX210S: FXS module, it supports two FXS ports.
AX210X: FXO module, it supports two FXO ports.
Slot1: A slot for plugging GX01, it is the first channel of the card.
Slot2: A slot for plugging GX01, it is the second channel of the card.
Slot3: A slot for plugging FXS/FXO module, it is the third and fourth channels of the card.
Slot4: A slot for plugging FXS/FXO module, it is the fifth and sixth channels of the card.
CON1: 4 pin power connector.
SW100: Used for selecting the way of power feeding, set it to 1 ON and 2 OFF, the CON1 provide
s the power for the card; set it to 1 OFF and 2 ON, the PCI slot provides the power for the
card. If the FXS port is used, the card must be provided power by the CON1. To ensure
the enough power feeding, user should choose the CON1 to provide power for the card,
and the SW100 is set to 1 ON and 2 OFF by default.
Hole: used for fixing the line which connect the GX01 to antenna.
Antenna: the antenna in the picture above is omnidirectional, the model is TS01
Attention: In order to enhance the GSM signal in some hard environment, except the Antenna in
the illustration above, ATCOM can also provide one other type of antenna(TL01)
which has long cable(about one meter long) and can be connected to outside.
RJ45: Used for connecting a splitter to the card, the splitter supports four RJ11 ports and one RJ45
port.
LED3: Used for checking if the FXS/FXO module is detected or not. When the FXS/FXO ports
are detected correctly, the LED3 will be on.