Install guide

www.atcom.cn
Channel 03: FXS Kewlstart (Default) (Slaves: 03)
Channel 04: FXO Kewlstart (Default) (Slaves: 04)
Channel 05: FXO Kewlstart (Default) (Slaves: 05)
5 channels configured.
Above message shows that AX-100p and AX-400p are already auto configured. You
can see that channel 1, 2 and 3 are configured as FXS_KS signaling, that means ports
1,2 and 3 will be act as FXO ports. And for the ports 4 and 5, they use FXO_KS
signaling and act as FXS ports.
Check AX-100p and AX-400p status:
Type
[root@asterisk1 ~]# zttool
Here the AX-100p’s state is RED, indicating that you haven’t connected the PSTN
lines to AX-100p. It shows OK after the PSTN lines is connected and ready for use.
Regarding the AX-400p, it shows OK all the time when the driver is install correctly.
After auto install the configure the AX-100p and AX-400p.
You also need to add two properties in the /etc/asterisk/zapata.conf file under the
[channels] section.
busydetect=yes
busycount=5
This two command is to enable the busy detect on the system. when you make calls to
a PSTN network, the other sides hangup the call , you will here the busy tone. If you
don’t enable busy detect. The system will regards the busy tone as a normal talking
tone, so it won’t hangup the line and other one can not call you.
12/32