Install guide

www.atcom.cn
3. Make outbound call
To make an outbound call, we need to add trunk first. There are many types of trunk,
SIP trunk, Zap Trunk and so on, We use AX-100p and A-400p to make zap trunks
here.
Install AX-100p and AX-400p to the PC (Hardware)
1. Power off Trixbox and pull out the power adapter.
2. Insert AX-100p card to the PCI slot of your PC and firm it with screw.
3. Insert AX-400p card to the PCI slot, please see below picture for the configure
port1
port3
port4
port2
Module
One
Module
Two
Module
Four
Module
Three
Power
Set up:
Insert AX-110X F
module 2, port 1 and port 2 will then be
configured as FXO
Insert AX-110S FX
module 4, port 3 and port 4 will then be
configured as FXS
If you have inse
AX-400p, because
signal to the norm
XO module to module 1 and
port.
S module to module 3 and
port.
rt AX-110S module to the
the FXS port need to provide
al phone, you also need to
power the AX-400p with your PC via the power port. Otherwise AX-400p won’t have
sufficient voltage to drive the normal phone connected.
AU-110S(FXS) AU-110X(FXO)
What are FXO and FXS?
FXS (Foreign eXchange Station) is an interface which drives a telephone or FAX
10/32