User manual

AT800 Series User Manual
ATCOM TECHNOLOGY CO., LIMITED www.atcom.cn
Tone
Set the ToneScript for each tone.
For example, MWI Dial Tone: 350@-19,440@-19;2(.1/,1/1=2);10(*/0/1+2)
Frequency1, Frequency2 ;Cadence Section1;Cadence Section2
350@-19: Frequency1 is 350HZ at -19dBm
440@-19: Frequency2 is 440HZ at -19dBm
2(.1/,1/1=2): Cadence Section length is 2s, 0.1s on, 0.1s off, with frequencies 1 and 2
10(*/0/1+2): Cadence Section length is 10s, always on(* means always, 0 means never), with frequencies
1 and 2.
 Country stands:---select a country standard tone as default.
 Dial Tone---Played when prompting the user to enter a phone number.
 Outside Dial Tone---An alternative to <Dial Tone> usually used to prompt the user to enter an
external phone number (versus an internal        
encountered in the dial plan.
 Busy Tone---Played when a 486 RSC is received for an outbound call.
 Reorder Tone---Played when an outbound call has failed or after the far end hangs up during an
established call.
 Off Hook Warning Tone---Played when the subscriber does not place the handset on the cradle
properly.
 Ring Back Tone---Played for an outbound call when the far end is ringing.
 MWI Dial Tone---This tone is played instead of <Dial Tone> when there are unheard messages in the
.
 Holding Tone---Indicate to the local user that the far end has placed the call on hold.
 Conference Tone---Plays to all parties when a Three way conference is in progress.
After finishing, click submit button to save changes.