User manual

AT800 Series User Manual
ATCOM TECHNOLOGY CO., LIMITED www.atcom.cn
Advance
1. Web Server
a) Enable Web Server: yes/no, enable/disable web server; system will reboot after
submit, if disable web server, the web interface will not be available anymore.
If web server is disabled on AT800/AT800P, it needs restore to factory settings by long
press * and # key when powering on. Please refer to How to restore to factory
settings.
b) Admin password: set admin password here
Tips: input http://ip-address/index in the browser to enter admin web interface.
c) User password: set user password here
Tips: input http://ip-address in the browser to enter user web interface.
d) HTTP Portthe web server port, default is 80. If user has changed the http port, e.g.
8080; to log in web interface by URI: http://ip-address:port in the browser.
2. VLAN
a) Use VLAN tagging: yes/no, enable/disable VLAN tagging, default to no.
b) Voice VLAN Identifierset voice VLAN identifier, range from 1 to 4096
c) Voice VLAN Priorityset voice VLAN priority, range from 0 to 7
d) Data VLAN Identifierset data VLAN identifier, range from 1 to 4096
e) Data VLAN priorityset data VLAN priority, range from 0 to 7
TIPS: The RTP/RTCP packet is voice packet, the others is data packet.
Notes: VLAN can only works in bridge mode. If you enable VLAN in router mode, it
will not work with VLAN.
3. Port Link
a) LAN port linkLAN port duplex mode
b) PC port linkPC port duplex mode
4. Qos