User manual

AT-640P User Manual
ATCOM TECHNOLOGY CO. , LIMITED
 out_access enable ： Select it to Enable out_ access rule.

Firewall Input Rule Table: Firewall input rule, as the picture config is deny
192.168.1.2 ping 192.168.10.2, but ping 192.168.10.0/24 beside
192.168.10.3 is ok.

Firewall Output Rule Table: Firewall output rule, as the picture config is the
phone ping 192.168.1.70 was deny.

Input/output: Specify current adding rule by selecting input rule or output rule.

Deny/Permit: Specify current adding rule by selecting Deny rule or Permit rule.

Protocol Type: Filter protocol type. You can select TCP, UDP, ICMP, or IP.

Port Range: Set the filter Port range.

Src Addr: Set source address. It can be single IP address, network address,
complete address 0.0.0.0, or network address similar to *.*.*.0 .

Dest Addr: Set the destination address. It can be IP address, network address,
complete address 0.0.0.0, or network address similar to *.*.*.*.

Src Mask: Set the source address ’ mask. For example, 255.255.255.255 means
just point to one host; 255.255.255.0 means point to a network which network
ID is C type.

Des Mask :
:
:
: Set the destination address ’ mask. For example, 255.255.255.255
means just point to one host; if set to 255.255.255.0 means point to a network
which network ID is C type.
4.5.
4.5.
4.5.
4.5. Qos
Qos
Qos
Qos