User manual

AT-640P User Manual
ATCOM TECHNOLOGY CO. , LIMITED
4.3.
4.3.
4.3.
4.3. Net
Net
Net
Net Service
Service
Service
Service
 HTTP Port: set web browser port, the default is 80 port ， if you want to enhance
system safety ， you'd better change it into non-80 standard port ； Example: The
IP address is 192.168.10.88. and the port value is 6090, the accessing address
is http://192.168.10.88:6090
 Telnet Port: Set Telnet Port, the default is 23. You can change the value into
others. Example: The IP address is 192.168.1.88. the telnet port value is 6023,
the accessing address is telnet 192.168.1.88:6023
 RTP Initial Port: Set the RTP Initial Port. It is dynamic allocation.
�
�
�
� RTP Port Quantity: Set the maximum quantity of RTP Port, the default is 200.
Notice:
Notice:
Notice:
Notice:
1 ） You need save the configuration and reboot the phone after set this page.
2 ） If you modify the port of Telnet and HTTP, you would better set the value more
than 1024 because the port value less than 1024 is system port reserved.
3 ） if you set 0 for the HTTP port, it will disable HTTP service.
4.4.
4.4.
4.4.
4.4. Firewall
Firewall
Firewall
Firewall
 in_access enable ： Select it to Enable in_ access rule.