User manual

AT-640P User Manual
ATCOM TECHNOLOGY CO. , LIMITED

Enable Session Timer: enable rfc4028 to refresh the SIP sessions.

Answer With Single Codec: only answer the call with a certain Codec.

Auto TCP: enable TCP transmission protocol when the length of message exceed
1300 byte.

Enable URI Convert: convert # into %23 when sending URI.

Enable Display name Quote: Set to make quotation mark to display name as the
phone sends out signal, in order to be compatible with server.

Enable GRUU: Set to support GRUU.

Enable Subscribe: Enable Subscribe: Overtime of resending subscribe packet.
Suggest using the default config.
3.2.
3.2.
3.2.
3.2. Iax2
Iax2
Iax2
Iax2 Config
Config
Config
Config
Above is the IAX server configuration page

IAX Server Addr: Register address of public IAX server.
 IAX Server Port: Register port of public IAX server ， default port is 4569.

Account Name: Username of your SIP account (Always the same as the
phone number).

Account Password: Password of your IAX account.

Local port: Signal port of local, default port is 4569.

Phone Number: Phone number of your IAX account.

Voice mail number: If the IAX support voice mail, but your username of the