User manual

AT820
AT820
AT820
AT820 Series
Series
Series
Series User
User
User
User Manual
Manual
Manual
Manual
32
ATCOM TECHNOLOGY CO., LIMITED www.atcom.cn
5
5
5
5 .5.1.5
.5.1.5
.5.1.5
.5.1.5 Control
Control
Control
Control Timer
Timer
Timer
Timer Values
Values
Values
Values (Seconds)
(Seconds)
(Seconds)
(Seconds)
A. Interdigit Long Timer: If the numbers or characters input are not finished and they
have not matched the full dial plan, the phone will wait for the long time that have
been set and then dial them out automatically. Range from 1 to 99, the default
value is 20.
B. Interdigit Short Timer: If the numbers or characters input have matched the full
dial plan, the phone will wait for the short time that have been set and then dial
them out automatically. Range from 1 to 99, the default value is 8.
C. Reorder Delay: The phone will wait for the reorder delay after far end hangs up to
play the reorder tone. 0 means playing it immediately. Range from 0 to 99, the
default value is 5.
5
5
5
5 .5.1.6
.5.1.6
.5.1.6
.5.1.6 Data
Data
Data
Data And
And
And
And Time
Time
Time
Time
A. NTP
1. NTP Server: Network time protocol service server, default is pool.ntp.org.
2. Time Zone: Choose the time zone.
3. Daylight Saving Time: Whether to enable Daylight saving time or not.
4. Daylight Saving Time Rule: This parameter is a rule with three fields, each field
is separated by semicolon; as show below:
Start=<start-time>; end=<end-time>; save=<save-time>
<start-time> and <end-time> specify the start and end date of daylight
saving time, month/date/week and <save-time> is the amount of
hour/min/sec to add to the current time during daylight saving period. The
<save-time> value can be preceded by a negative (-) sign if subtraction is
desired instead of addition.
If <weekday > is 0, it means the date to start or end daylight saving is at