User manual

AT-323 IAX2 Phone User Manual (V1.43)
7
3. Configuration
Four different ways can be used to configure AT-320 IP phone: phone
keypad, web browser, Telnet commands and PalmTool configuration tool on
computer.
3.1 Phone Keypad setup
3.1.1 Function Keys Introduction:
When using keypad and LCD to configure the settings of IP phone,
following keys will be used:
Keys Function Keys Function
SET/LOCIP
Enter setting mode
OK/Speaker
Enter submenu; confirm change
VOL+
Turn over menu
backward
VOL-
Turn over menu forward; move
cursor backward
Digital key
Modify values
EXIT/Redial
Exit current menu; exit setting mode
● Enter the keypad setting mode
Press “Speaker” keyÆenter “1234#”Æyou can see LCD display
password”Æenter “1234”Æpress “speaker” key to confirm.
● Select the submenu
After entering the main menu, press “VOL+” or “VOL-” to page the menu up
or page the menu down; when you want to set the submenu item to be
displayed, press “OK/speaker” to enter the submenu.
● Enter the EDIT mode
After entering the submenu, when you want to set the submenu item to be
selected, press “Set” to enter EDIT mode.
● Enter the settings
Once the phone enters EDIT mode, enter the settings by numeric keypad
respectively, then press “OK/speaker” key to confirm.
● Modify enter error
If the errors come forth when you enter the settings, press“VOL-” key to
delete it and enter the settings again
● Abort the settings
If there is no need for the modified settings, press “EXIT” key to
return to the main menu, and press “VOL+” or “VOL-” to page the menu up
or page the menu down; When “exit settings” submenu item is selected,
press “
OK/speaker” key to confirm, AT-320 IP phone will reboot and be
used the current settings.
Keison Products www.keison.co.uk [e-mail] Tel: [phone]