User manual

AT-323 IAX2 Phone User Manual (V1.43)
41
Q5 How to update the protocol for the AT-320/AT-323?
A: Please refer to chapter 4
Q6 After updating AT-320/AT-323 ,the LCD shows " ■■" and
stops ,how to deal with it?
A: (1) Reset to the factory default; if it still can’t solve the problem ,pls. refer to
(2).
(2) Enter into the safe mode (press " * "button ,then power on till the LCD
shows" *" ) and re-upgrade the IP phone by Palmtool. ( please refer to Q3,
AT320 will have default IP 192.168.1.100 in safe mode)
(3) If you can’t solve the problem , pls. return the phone to the reseller for
repairment .
Q7 Why is the local IP 0.0.0.0?
A:If the AT-320 “IPtype” is set to “DHCP” and your network doesn’t support
DHCP function.The AT-320 will shows “0.0.0.0”. Pls. Check your network in
this case.
Q8 Why is the local IP 255.255.255.255?
A: Probably IP phone fails to get IP address if you choose the “IPtype” to
PPPOE, you can set your AT-320’s “IPtype” to “static” or “DHCP” through
keypad(please refer to chapter 3.1). or reset to the factory default.
Q9 How to reset the AT-320/AT-323 to the factory default?
A: Power off ,then press“*” and power on(Don’t lose the * until the LCD shows
“page0 running”or“*”) , press “#5*5”
Q10 How to use the fast dial-up function?
A: Use Palmtool or IE to enter into the setting page, find the address book, fill
the name and the full number in the right blank. For example: fill “Jack” in the
blank after 001,input 56489237 in the blank of phone number, then , Jack’s
number of 56489237 will be saved in the first position . After setting all of the
number, press save button,then return to the phone. press speaker + 001 +
speed button , then the phone will dial-up 56489237 automatically. Or use the
9 speed dial key on the top side of the phone: press speaker, then press one of
the 9 speed dial key and then press speed key
Keison Products www.keison.co.uk [e-mail] Tel: [phone]