User manual

AT-323 IAX2 Phone User Manual (V1.43)
19
selecting this item.
 no check: Disable checking firmware tags when upgrading. This is not
suggested, because it will increase the risk of upgrading the wrong
firmware into the phone.
3.2.5 Other settings:
Fig 3.6 Other Setting Page
● password: Set the password of the phone. (Default password is 1234).
● upgradetype: Set the auto-upgrade type of the phone.
 disable : Disable auto-upgrade .
 all: AT320 will find matching firmware binary file and configuration file
of the hardware type only at the FTP server specify by upgradeaddr
item .
 mac: AT320 phone will find matching firmware binary file and
configuration file of the MAC address only at the FTP server specify by
upgradeaddr item .
 ppp id: AT320 phone will find matching firmware binary file and
configuration file of the ppp id only at the FTP server specify by
upgradeaddr item .
 account: AT320 phone will find matching firmware binary file and
configuration file of the account only at the FTP server specify by
upgradeaddr item .
 phonenumber: AT320 phone will find matching firmware binary file
and configuration file of the phone only at the FTP server specify by
upgradeaddr item .
● upgrade addr: Put IP address or domain name obtained by ISP of FTP
server supplying upgrade program into this field.
● sntp IP: Fill IP address of time server here. When network without
Internet connect, Fill special IP address 255.255.255.255.
● use daylight: Enable/disable daylight.
● timezone: Select correct time zone in list box.
When debug set as 0[disable], if input ordinary password (default one is 1234),
then following page will pop up after clicking
. And only those
Keison Products www.keison.co.uk [e-mail] Tel: [phone]