User manual

AT-323 IAX2 Phone User Manual (V1.43)
18
3.2.4 IAX2 Protocol Settings
Fig 3.5 IAX2 Protocol Settings
● service addr: Please set the URI (domain name/IP address : service port)
of the asterisk server into “service addr”. When the default service port
4569 is used, “: service port” can be omitted.
● register ttl : IP phone will send a keep-alive registration message to
theasterisk server every “register ttl” seconds. The minimum value is 10,
maximum value is 65535. Default is 60.
● phone number: The local phone number or username of this phone,
usually is allocated by system.
● account: With the asterisk server which requires authentication, please
put the username/account into this field.
● pin: With the asterisk server which requires authentication, please put the
password into this field.
● local port: The local UDP port registered with the asterisk server to
accept incoming handshaking messages. The default port number is
4569.
● dtmf: Set DTMF signal sending way by selecting inband audio, outband
audio from list box.
● tos: Set the TOS field of the IP header of the RTP packets. The bigger this
value is 0, the higher priority the packet is .
● super password: Set the super password of the phone.(Default super
password is 12345678).
● debug: Set the debug level of the phone.
 disable: Disable output the debug message by selecting this item.
 output: Output the operation information to the window, such as
register, input by selecting this item.
 output all: Output all debug information and data in test window by
selecting this item.
 remote debug: Save the debug information in SDRAM of IP phone by
Keison Products www.keison.co.uk [e-mail] Tel: [phone]