User manual

AT-323 IAX2 Phone User Manual (V1.43)
13
3.2.1 Network Setting
Fig 3.2 Network Setting
● IPtype: Set how IP phone gets relevant network parameters by selecting
corresponding item from drop down list.
 static IP: Select this item to authorize users set IP address, subnet mask
and router IP address of IP phone manually.
 dhcp: Select this item to enable DHCP mode. With this system, your
LAN or router automatically assigns all the required network parameters
to any device connected to it when the device log on. AT-320 IP phone
is shIPped from the factory with DHCP on. So, if your LAN or router is
configured to use DHCP addressing, the IP phone’s LAN parameters will
automatically be configured as soon as it is connected to the LAN or
router and powered up.
 PPPoEThose ADSL and Cable Modem users please select this item for
it is a protocol especially designed for them. With this system, ADSL ISP
automatically assigns all the required IP parameters to any device
connected to it when the device log on.
 modemIf the IP phone used with modem, please select this item to get
relevant network parameters auto. Then please fill ID and pin into ppp id
and ppp pin fields.
● ppp id: With PPPoE or modem selected in IPtype drop down list, please
enter the user name here.
● ppp pin: With PPPoE or modem selected in IPtype drop down list,
please enter the password here.
● local IP: With static IP selected in IPtype drop down list, please enter IP
address of IP phone here.
● subnet mask: With static IP selected in IPtype drop down list, please
enter subnet mask of IP phone here.
● router IP: With static IP selected in IPtype drop down list, please enter
router IP address of IP phone here.
Keison Products www.keison.co.uk [e-mail] Tel: [phone]