User manual

www.atcom.cn
40/40
file zapata.conf to set the
usecallerid=yes
notice: you will need to remove the channel defined line (channel => 1,2,3,4 etc.) in the
Zapata.conf file because the Ip04 will auto detect the channels after reboot. If you have modify
the zapata.conf file, you may see double lines with channel in the zapata.conf file after reboot, it
will cause problem to start the zaptel channels.
10.11 HOWTO – set CallerID for UK?
Make sure that you have below packages installed in the IP04:
libtiff spandsp asterisk-spandsp
in the zapata.conf file, change the setting to:
immediate=yes
usecallerid=yes
cidsignalling=v23
cidstart=polarity
callerid=asreceived
hidecallerid=no
then reboot.
notice that you need to remove the line
channel => 1,2,3,4 in the Zapata.conf file if you have modified this file. Otherwise you will have
double defined after reboot.