User manual

www.atcom.cn
45/
ip04>nand erase clean
ip04>nand erase
(Notes: During TFTP transfer, successful transferring will show alot of #'s, while
timed out requests will display T's instead. Don't worry if it finds some bad blocks
during the erasing.)
8.
ip04>nand write 0x1000000 0x0 0x700000
ip04>setenv bootargs ethaddr=$(ethaddr) console=ttyBF0,115200 root=/dev/mtdblock0 rw
ip04>setenv autostart yes
ip04>setenv nandboot 'nboot 0x2000000 0x0'
ip04>setenv bootcmd run nandboot
ip04>save
ip04>reset
9. The unit will now reboot using the newly flashed firmware, and should start
downloading necessary files and completing the installation. Once it has completed
and you're presented with a penguin and the "root:~>" prompt, enter the following
command for a final reboot:
root:~> reboot
10. When done booting and back to the "root:~>" prompt, you may enter the following
command to check the unit's current IP address:
root:~> ifconfig
11. Use that IP address to configure the unit through your web browser. Alternatively
you may change the IP address temporarily (this change is lost when you power the
unit off or reboot it, so set it permanently in the web GUI):
root:~> ifconfig eth0 <ip address>
(Replace <ip address> with the ip address of your choice.)
4.4 How to change my IP address?
Go to Options--> Advance Options-->Show Advance Options. Then you can find the network
settings in the main menu.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]