User's Manual

ѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧѧʳ SC-T8000 Fast Installation Guide
follow step 3 to install the next sensor
installation, after finishing press Key4 (Exit).
*attention: Finished installing, LED
shows “red “, If you set different sensor
ID in the same place, the LED will
disappear, at this moment you must
reset the sensor.
θ Signal ι
1. Normal:
When tires operate in normal condition, LED
shows “green” light. Every 8 sec., the “orange”
light takes turn to show each tire’ s condition.
2. Abnormal:
When tire is in over-heated, over-pressured, or
under-pressured condition, LED shows “red”
light, locks on the position of over-heated tire
with “beep” sound.
Ϡ NOTEΚTwo tires are abnormal at the same time,
it will be fixed on the abnormal status.
3. Receiver did not receive Data:
If receiver can not receive updated tire messages
over 10 mins., LED shows abnormal indication.
Example:
Left-front tire didn’t receive data, shows “ t l ----”.
Right-front tire didn’t receive data, shows “ t2 ----”.
Left-rear tire didn’t receive data, shows “ t3 ----”.
Right-rear tire didn’t receive data, shows “ t4 ----”.
*attention: The abnormal signal will be
disappear after once messages received.
If long time no new information, please
check your sensor.
θ FCC Notice ι
The changes or modifications not expressly
approved by the party responsible for
compliance could void the userϗs authority to
operate the equipment.
THIS DEVICE COMPLIES WITH PART
15 OF THE FCCRULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO
CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE
(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
Caution: Any changes or modifications in
construction of this device which are not
expressly approved by the party responsible
for compliance could void the user ϗ s
authority to operate the equipment.