User's Manual

Copyright (C) ATBS Technology Co. R4.5e
iTPMSystem for iPod, iPhone, iPad User’s Guide
1. Introduction
This Tire Pressure Monitoring System (TPMS) was
designed for increasing security, reliability, and
understanding on tire conditions of your car. Once you
properly install the TPMS, these sensors will
automatically monitor pressures and temperatures of tires
in real time, and send these data to Receiver through
Bluetooth communications. When there is any abnormal
pressure (under or over inflated) and/or temperature of
tire detected, iPhone, iPod, and iPad will alert driver
immediately. This system could ensure you are driving in
safety.
About This Manual
 The information in this manual is subject to change
without notice.
 This manual has been created with extra care. In
case that you have any comments or questions
regarding this manual, please contact your local
dealer or our Customer Service Center.
 Before operating this set, please fully understand
the prerequisite such as specifications or
constraints of the hardware and software. We are
not responsible and have no liability for any loss,
damage or injury as a result of misuse.
2. Check Accessories
Part
Photograph
BT6000C-A
BT6000C-M
Receiver
1
1
S
e
n
s
o
r
A-type
4
0
M-type
0
4
Cable
(OBDII to
Mini USB)
1
1
Cap parts
0
4
Lock Nut
4
0
Tool
1
0
User Guide
1
1
Velcro
1
1
3. System Installation
3.1 Install Receiver ：
3.1.1 Plug in OBDII connector.
3.1.2 Plug in mini USB into the receiver.
3.2 Install A-Type Sensor:
3.2.1 The sensor label already indicates the sensor ID
and its wheel order.
Example:
Sensor Model: AT67
Wheel Order: 01:L1
ID:3C0886B5
3.2.1 Place batteries into the
sensor and screw the top cap of. Please attend to the
electrode of the battery.
3.2.2 Remove original valve cap and screw lock nut (1)
and become (2). Screw the Sensor onto valve stem
clockwise (3). Screw (1) lock nut back and use wrench
to to lock tightly (4). (3)(4) steps could effectively prevents
sensor from removing.
Note ：
(1) Beware of the conductivity between the sensor
and valve stem.
(2) Sensors are supposed to be well locked valve
stem to avoid from leaking.
(3) Please replace sensor battery in case voltage is
below 2.6v.
3.3 Install M-Type Sensor :
3.3.1 Check sensor ID & configures tire.
There are initial sensor configured locations marked.