User's Manual

AT6X User’s manual www.atbs.com.tw

Installation the Sensor

1. Install battery into sensor and tighten sensor top cap.

2. Check Sensor ID:

Each sensor should be assigned a unique identification

number (ID).

3. Remove original valve cap and screw lock nut first

then sensor onto valve stem.

4. Sensor onto valve stem

5. Screw lock nut back and using Wrenches to lock tight. This prevents sensor from

PAGE 1
AT6X User’s manual www.atbs.com.tw Installation the Sensor 1. Install battery into sensor and tighten sensor top cap. 2. Check Sensor ID: Each sensor should be assigned a unique identification number (ID). 3. Remove original valve cap and screw lock nut first then sensor onto valve stem. 4. Sensor onto valve stem 5. Screw lock nut back and using Wrenches to lock tight. This prevents sensor from Copyright (C) ATBS Technology Co.
PAGE 2
AT6X User’s manual www.atbs.com.tw easy removing also in favor of sensor stationary. Note: User may ignore this fixture, when causing inflation hassle concerns. 6. Continue to install all other sensors with the same procedure. ＊ Note：Clean up the valve stem surface before installation to ensure the conductivity between sensor and valve.