Instruction Manual

3. Velocity deviation is more than 1%

Check the hammer guide for any unauthorized objects, grease, dirt

and clean it;

Substitute the pellets for those of higher quality;

Increase the gap between shots to 10-30 seconds.

4. The rifle is slowly leaking

Determine the leaking area: apply oil or kerosene to the places shown

at Fig. 8. Foam (bubbles) will appear at the leaking place. Remove the

damaged O-ring.

Check if the tank discharging screw is tight. It is common to forget to

tighten it after the rifle disassembly! Do not apply excessive force!

5. Accuracy issues

Clean the barrel;

Substitute the pellets for those of higher quality;

Check the gripping of the barrel to the receiver as well as the muzzle

unit on the barrel.

6. While charging, the air goes out of the probe, but the tank isn`t filled

Replace the filling probe or its O-rings;

Loosen the filling valve screw for ¼ turns (or contact the

manufacturer).

In case you couldn’t solve the problem by yourself, please con-

tact the manufacturer or any authorized service center.

Fig. 8 – Leaking check