Instruction Manual

15
Barrel dismounting and mounting
Required for periodic checkup and cleaning (see Fig. 8).
• Using the Allen key untwist barrel adjustment screws in the upper
side of the reciever;
• Carefully remove the barrel;
• Mount the barrel into the receiver so that its flat surface was
located under the barrel adjustment screws (flat surface on top);
• Tighten the barrel adjustment screws. Be careful not to tight the
screws over 6 N.
Storage and transportation
Storage and transportation of the rifle are only to be carried out
with no pellets in the barrel and the hammer de-cocked!
The rifle must be stored in conditions assuring its safekeeping,
safe storage and excluding any unauthorized access.
To be kept in operating conditions, the rifle must be cliened and
dried. The hammer and hammer guide must not be lubricated, as this
unit is most stable at dry friction conditions. All the other metal parts
Fig. 8 – Discharging the tank.
1 – tank discharging screw; 2 – Barrel adjustment screws.