Instruction Manual

14
airgun.
• Do not charge/fill your airgun if there are children and/or pregnant
women present nearby.
Charging/filling procedure:
1. Attach the filling adapter to the com-
pressed air source and tighten the bleed-
ing screw.
2. Carefully insert the filling probe into the
front plug filling port until the end.
3. Fill the airgun with compressed air (Fig.
7) until the desired level.
4. Close the valve on the compressed air
source.
5. Depressurize the filling adapter using
the bleeding screw and remove the probe
from the filling port.
Fig. 7 – Charging the tank.
Always wait until the filling adapter is fully depressurized!
Insert and remove the filling probe without effort in order not to
damage the O-rings.
It is recommended to occasionally apply silicone vacuum grease
or oil to the filling probe O-rings.
Discharging the tank
The under-barrel tank is depressurized by loosening screw 1 (Fig.
8). The tank will be fully depressurized in several minutes. Take a dry
shot to check if the tank is fully depressurized. Lack of the air hissing
doesn`t mean that the tank is fully depressurized. Use the front
plug gauge to monitor the tank pressure. When the tank is depressur-
ized, tighten screw 1.