Instruction Manual

the pull.

After the lockwork adjustment it is necessary to check the rifle for

safety use (spontaneous hammer disengage from the sear):

• Cock and shoot the rifle several times without pellets, only using

air, to make sure that the engaging of the hammer and the sear

occurs every time. This must be done with the receiver cover

removed in order to monitor the lockwork performance;

• Put the safety on and off several times and make sure that a shot

doesn`t occur with the safety on;

• Tap the receiver of the cocked rifle with wooden or rubber

hammer. Make sure the tapping doesn’t lead to the lockwork

parts displacement;

• After the action is attached to the stock, cock the rifle and

carefully tap the rifle backplate at plain firm surface from 20-30

cm / 8-11 inches. Make sure no shot occurs;

• Check the safety performance. If the safety lock isn`t moving to

the right, rotate the adjustment screw for ½ turns

counterclockwise.

If all the procedures are in accordance to the manual, the rifle is

safe to use with the new lockwork settings.

If some steps of the checkup fail, it is necessary to increase the

sear engagement and/or trigger pull.

Charging the tank

Use filtered and dried compressed air to charge/fill your airgun.

Check the filling probe and the front plug filling port for any damages

or mud.

Always follow the safety code when charging/filling your airgun:

• The airgun must be charged/filled ONLY WITH THE LEVER

OPEN!!!

• The airgun must be placed horizontally on a flat surface and

perpendicular to the hose with a filling probe.

• It is forbidden to bend the filling hose when charging/filling the