Instruction Manual

Check the gripping of the pellets in the magazine by O-rings so that

the pellets wouldn`t fall off. If required, the O-rings can be lubricated or

replaced if damaged.

Shooting procedure

1. Open the bolt. In order to do it, move the bolt lever handle to the

forwardmost position.

There must not be any obstacles when opening the bolt!

2. Send the pellet into the barrel by closing the bolt.

3. Take a shot at the desired target by gently pulling the trigger.

4. Repeat the procedure from p. 1 to p. 3 for subsequent shot.

Monitor the gauge for the tank pressure. If it is lower than the

operating level requires, charge the rifle with compressed air.

5. Having finished shooting, take a dry shot to the ground.

Maintenance

Lockwork adjustment (Fig. 6).

Fig. 6 – Lockwork.

1 – hammer spring; 2 - hammer; 3 – valve stem; 4 - sear; 5 – secondary sear;

6 – trigger drawbar; 7 – trigger blade; 8 – trigger pull adjustment screw; 9 –

secondary sear spring; 10 – safety; 11 – trigger creep adjustment screw; 12 –

plug; 13 – valve; 14 – bolt assembled; 15 – bolt cover; 16 – receiver plug; 17 –

adjustment screw.

• Valve 13 opening time is fine-tuned by rotating the adjustment

screw 17.

• Trigger pull is adjusted by screw 8. Clockwise rotation increases