Instruction Manual

11
Fig. 3 – Installing the safety.
Loading the magazine
Load the pellets into the magazine
until they are fixed with the O-rings as
shown at Figure 4. Do not allow the pellets
to protrude out of the magazine surface.
Fig. 4 – Loading the magazine
Installing the magazine
Open the bolt until the end, put in
the magazine from above into the
switch casing.
 Opening the bolt will automatical-
ly rotate the magazine thus opening
the next chamber.
 The magazine loading procedure
is to be repeated after the last
shot.
Fig. 5 – Installing the magazine.
Do not use damaged or dirty pellets. Do not reuse the pellets.
Do not use the pellets protruding from the magazine chambers.