INSTRUCTIONS FOR USE GB Postbus 1033. 6920 BA Duiven. Nederland 24 325 88-9132 Rev.
Congratulations from ATAG Dear Customer, Congratulations with your new Hob. It is important that you become familiar with the functions and features of the Hob. You should therefore read these operating instructions as they will help you get the most out of your new Hob. Pay extra attention to sections marked . These are warning texts to help you avoid accidents. Keep the operating instructions.
Table of contents Contents Page no For the user Your new appliance ...................................................................................... 2 Safety information ........................................................................................ 4 Description of the product ......................................................................... 5 Placement of grid ................................................................................. 5 Operating instructions ................
Safety information Never leave the hob unattended while deep fat frying, or heating fats and oils. These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. The appliance is not intended for use by young children or infirm persons without supervision.
Guarantee Description of the product Please refer to the accompanying guarantee booklet and guarantee card for guarantee conditions.
Operatings instructions Burner markings The operating knob has a ring showing the scale of markings. Service Question: Answer There is no spark when lighting the gas? Check whether the 230 V connection has been plugged in. The ground fault circuit relay way have switched off. The fuse has blown When the operating knob is released the gas ring goes out again? The operating knob has not been depressed long enough, or has not been depressed sufficiently.
Technical data Model: WO3011AA20BE/A1 Burner cover/inner burner ring/outer burner ring Type of gas Adjusted for: Natural: G-20 - 20mbar G-25 - 25mbar Category and pressures 20/25 - 28/37 mbar BE: II 230 V 1N + PE N 2E+3+ L1 The Dropinett must be connected via an external switch with a contact gap of min. 3 mm (the main switch may be used) Max.
An opening with a minimum area of 60 cm2 must be present at the back of the cupboard (see fig.).
Please note: If the wok is mounted in a table top with a cupboard underneath, the flame might be blown out if the door is slammed. Gas installation In accordance with local requirements for domestic gas cooking appliances. Gas installation must only be carried out by an authorised person. For gas types see technical data. The wok-unit has a special pan support which enables use of a wok pot with curved bottom.
Ignitions 1. Depress and turn the control knob for the burner, the left to 2. The ignition electrode will emit sparks, and when the mixture of gas and air is correct, the burner will be ignited. Is not possible to connect the unit to mains, a match may be used to ignite the burner 3. After starting the burner, press the control knob for approx. 10 seconds to activate the automatic thermo couple. 4. Important Ignition position is at 3. Place the cover plate over. See fig. 3. Fig. 3 Fig. 4 4.
Cleaning and maintenance of Stainless steel surfaces Installation of wok burner It is extremely important that both the inner and outer burner rings are fitted correctly into their “guide notch”, otherwise the burner will burn with an incorrect flame pattern and could be ruined within a very short period. You must be able to hear a click telling you that the rings have been correctly fitted. Air valve Fig. 1 Perform daily cleaning with a slightly damp cloth. For more severe soiling, use a liquid cream.
Mounting MIN 55 Caution: In order to avoid a hazard this appliance must be installed according to these instructions for installation The hob unit can be mounted in any type of kitchen with a table surface whose thickness is between 28 mm and 40 mm. It is not necessary to attach the reinforcement beam to the work top surface, as it is held in place by a specially designed moulding, which is incorporated in the hob units flanges.
