User manual

2. Select the lowest setting for water hard-
ness and rinse aid dosage.
If the drying results are not satisfactory
we recommend that you:
1. Fill up the rinse aid dispenser with rinse
aid.
2. Set the rinse aid dosage to position 2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
again.
2. Adjust the water hardness setting to the
highest setting and perform 1 normal
washing programme without loading any
dishes.
3. Adjust the water hardness setting ac-
cording to the hardness of the water in
your area.
4. Adjust the rinse aid dosage.
Select and start a washing programme
Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme (refer to 'Washing
programmes'). The indicator light of the
selected programme comes on.
5. We suggest to select the half load option
if only a few dishes need washing. Check
if the option is selectable with the washing
programme. (Refer to 'Washing pro-
grammes').
6. Close the dishwasher door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the indicator light corresponding to the
chosen hours flashes (3h, 6h or 9h).
2. Close the dishwasher door, the count-
down starts automatically.
3. The countdown will decrease with steps
of 3 hours.
4. Once the delay start has elapsed the pro-
gramme will start automatically.
The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
Cancel a delay start or a washing
programme in progress
• Simultaneously press and hold the two
function buttons B and C until all the pro-
gramme lights come on.
• Cancelling a delay start will also cancel the
washing programme. You have to select
the washing programme again.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop and
an audible signal informs you of the end of
the washing programme.
1. Open the dishwasher door.
–
The End indicator light is on.
– The indicator light of the programme
just ended remains on.
2. Switch of the dishwasher.
12