Operation Manual

Operating instruction ATAG Premier page 7
Adjusting the type of installation
The boiler is designed in such a way that it will adjust itself automatically
to what is necessary for a normal heating system. In some cases the
installation may have convectors or complete underfloor heating. One
can easily choose the type of heating installation adjustments that
belongs to the system such as maximum flow water temperature or for
the warming up of the installation after a night period. To make
adjustments:
- Push the step key (
)again after the adjustment of the maximum
flow water temperature is shown the reading
.
The display will show the reading
. This means that in this
case adjustment 1 is active, and that, for this installation type 1 has
been chosen.
- By means of the (
) + or the ( )- key the desired installation type
can be chosen.
- The choice has to be confirmed with the store key(
)
The display will flash once after which one can return by means of the
mode key ( ) to the reading or the technical reading .
noitallatsnI
eciohc
metsysgnitaehlartnecfoepyt
retawwolf
erutarepmet
1
srotcevnocgnitaehriadnasrotaidar C°58
2
gnitaehroolfrednurosaeraecafrusegralhtiwsrotaidar C°07
3
gnitaehartxerofsrotaidarhtiwgnitaehroolfrednu C°06
4
gnitaehroolfrednuetelpmoc C°05
= factory setting
Described above is which installation type can be chosen.
When a type of installation has been chosen with a low flow water
temperature it is possible that in case of a severe winter period the
temperature of the heating system will need to increased slightly. In
such situations the installation choice may need to be changed, so a
higher flow temperature can be chosen.
More adjustments are defined in the installation instructions.