Operation Manual

Operation instructions ATAG Premier page 6
The Reset key( )
The control panel is provided with a reset key. When a fault occurs it
will be shown by the flashing
EE
EE
E of Error with a certain numbercode after
which the boiler is shut down. After pressing the reset key ( )you can
try to start the boiler again. If the defect keeps returning contact your
installer.
Adjusting the flow water temperature
For the user who has chosen the technical reading according to page
5 you can easily adjust the flow water temperature to his or her own
wish. In order to adjust the flow water temperature the following actions
have to be taken.
- Push the mode key briefly. (
).
The display will show the text
which means that in this
chapter adjustments can be made.
- Push the step key (
).
The display will now show
The first figure indicates which
adjustment is being shown and the third and the fourth figure
shows the value of this adjustment. The standard adjustment is
85°C flow water temperature.
- By means of the + or - key this value can be changed.
- Push the Store key (
) to confirm the adjustment.
The display will flash once.
- Push the Mode-key briefley (
).
The technical reading is shown again.
The flow water temperature that has been adjusted only applies to the
central heating and is independent of the hot water facility for the
calorifier.