Operation Manual

Operating instruction ATAG Premier page 5
During severe frost: It is possible when there is no
outstide sensor connected, to choose manually to let the
circulation pump circulate continually to reduce the
chance of freezing in the case when there are pipes
(garage, attic or other cold spaces / rooms) which are
sensitive to frost.
Secondary function
-key: storing (Store) of value in the
-chapter (see page 6).
The reading
During this reading the display will only show what is necessary. Under
normal circumstances the display will give a
reading and if a
fault is established this will be reflected with the E for error and a certain
number code.
Choosing a technical or a reading.
In order to switch from a reading to a technical reading for
example
the step key should be pushed for 5 seconds.
To return to the
reading the step key should be pushed for 5
sec-onds again.
The technical reading
During this reading the display will show in which operating status the
boiler is active. The technical reading
is being repeated every
2 seconds along with the reading of the waterpressure
.
The first figure of the technical reading
indicates the status in
which the boiler is active and the third and fourth figure indicate the
water temperature of the boiler. In case of the reading
the
character P stands for pressure which represents the waterpressure.
The third and fourth figure indicate the water-pressure in bar. When a
fault occurs it will be shown by the E of Error with a numbercode.