Operation Manual

Operation instructions ATAG Premier page 4
The boiler
The casing of the boiler consists of synthetic material which can be
cleaned with a normal non-abrasive cleanser. After opening the door, the
control panel with the function keys is clearly visible. The control panel is
provided with a number of push-buttons with corresponding lights.
Program keys with indication lights
Press this key in order to turn on and off the central heating
program. This program will become active when the
key is
pushed and the indication light is illuminated. In this case the
boiler will activate the burner when the room thermostat is
calling for heat.
Secondary function
-key: raises (+) a certain value in the
-chapter (see page 6)
Press this key in order to turn on and off the hot water program.
This function only works in the case of an boiler on which a hot
water facility is connected. This programm will become active
when the
key is pushed and the indication light is
illuminated. In this case the boiler will activate the burner when
the calorifier thermostat is calling for heat.
Secondary function
-key: lowers (-) a certain vaue in the
-chapter (see page 6)
Press this key in order to let the circulation pump circulate
according to the automatic switch program or continually via
the central heating installation. The circulation pump will
circulate continually via the central heating installation when
the key
is pushed and the indication light is illuminated. In
most situations the program can stay on automatic, so that the
circulation pump starts functioning as desired for central
heating or hot water. If an outside sensor is connected to the
unit the pump will start automatically in case of a low outside
temperature in order to reduce the chance of freezing.