User manual

CAUTION! Do not use the
appliance without the glass
panels.
The direction in which you open
the door depends on your oven
model. You open the door from
the right side in some models
and from the left side in others.
1. Press the buttons at the sides of the
door trim (A) on the upper cover and
pull it upwards to remove it.
A
2. Hold the inner glass B tightly with both
hands and slide it upwards to remove it
from its initial position. Do the same
with the second glass panel.
Make sure that you tightly hold the
glasses to prevent them from falling.
B
3. Clean the door with a wet sponge and
rub it dry with a soft cloth. Do not use
steel wool, acids or abrasive cleaning
agents because they can damage the
surface.
When the oven door is clean, install the
glass panels in the opposite sequence. The
middle glass panel has a small dot on the
top and the second one has screen
printings. Make sure that you put the
middle glass panel in the correct seats. The
screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame is not rough when you touch it.
A
B
Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING! Danger of
electrocution! Disconnect the
fuse before you replace the
lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION! Always hold the
halogen lamp with a cloth to
prevent grease residue from
burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
18