User manual

ATAG 53
Electronic programmer
Setting the time
1 Time button
2 Minus button
3 Plus button
4 End time LED
5 Cooking time LED
6 Meat probe LED
7 Minute minder LED
8 Clock LED
9 Display reading
Setting the time
After the electricity has been connected or after a
power failure, the Clock LED flashes.
Setting the time
1. Set the current time using the or button.
2. Wait for 5 seconds: the appliance is now
in normal mode (operating mode).
Changing or correcting the time
3. Press the time button repeatedly
until the Clock LED flashes.
To correct the time proceed as in steps 1 and 2.
Note
The time can only be changed if no automatic
function (e.g. automatic turn on/off) has been
programmed.
The electronic programmer has the following
functions:
• Displaying the time
• Minute minder (alarm)
• Safety cut-out
• Automatic turn on/ off
• Meat probe