Operation Manual

31
Door replacement
Feed water pipe installation
Pass the refrigerator laterally through the access
door as shown in the right gure.
Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm
2
) (That is, an instant paper cup (180 cc) will be fully lled within 3 sec.).
If water pressure does not reach the rating 147 kPa (1.5 kgf/cm
2
) or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
Keep the total length of the feed water pipe tube within 8 m and be careful for the
tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed
owing to the drain water pressure.
Install the feed water pipe tube at a place free from heat.
Connect to potable water supply only.
Refer to instructions with water lter kit for installation.
Mount them in the reverse sequence of removal after they pass through the access
door.
Pass the
refrigerator
Before
installation
Warning
1
2
3
4
5
M
a
x
F
R
Z
T
E
M
P
R
E
F
T
E
M
P
M
in
5
43
2
1
M
a
x
Installation