Operation Manual

18_ setting up
3. After adjusting the doors, turn the nut
1
clockwise until it reaches the lower end of the
bolt, then tighten the bolt again with the wrench
3
to fix the nut in place
1
.
If you do not secure the nut firmly, the bolt may release.
CloseMain
Waterpipe
CloseMain
Waterpipe
NOGAP
3
2
1
Wrench
Bolt
Nut
CHECKING THE WATER DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features on your new refrigerator. To help promote better health,
the water filter removes unwanted particles from your water. However, it does not sterilize or destroy
microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to
operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup
can be lled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below 138 Kpa),
you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside
the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water
outlet.
Water Line installation Kits are included with unit. You can nd it in freezer drawer.
INSTALLING THE WATER DISPENSER LINE
ForInteriormodel
Parts for water line Installation

1

Waterlinexerand
screws

2

Pipeconnector

3

Waterline

4

WaterFilter
Connecting to the water supply line
1. first, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in the
installation kit.
CAUTION
The water line must be connected
to the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
4. After connecting the water supply to the water lter, turn your main water supply back on and
dispense about 1l to clear and prime the water filter.
DA99-02208A(0.1).indb 18 2009.11.17 1:23:35 PM