Operation Manual

EN 34
SERVICE
Additional service requirements for the integration (flush installation) of the
hob (‘SI’ and ‘SVI’ models)
• Once it has been integrated, the hob must remain accessible from
underneath for service purposes.
• If a drawer or oven is built in under the hob it must be easily
removable.
• These hobs are particularly suitable for integration in stone or tiled
worktops.
• Report any transit damage before sealing the hob. Any damages
reported afterwards will be deemed a result of it being built in.
• The guarantee does not cover damages resulting from the hob
being built in.
• The guarantee does not cover water damage or any other damage
to the worktop the hob is built into.
• Prior to any service call, all interior parts of the cupboard the hob is
built into, such as drawer constructions, shelves, racks and runners,
are to be removed.
• The service department is responsible for the repair and service of
the hob only. You should contact your kitchen specialist about the
re-integration (flush installation) of the hob.
• The kit used to seal the edges of the glass top must be resistant to
temperatures of at least 160 °C.
• To prevent discolouration of the natural stone, use a specially
developed sealant between the glass and natural stone.