Operation Manual

EN 21
TROUBLESHOOTING
FAULT CAUSE SOLUTION
A burner does not ignite. Control knob not kept pressed
in far enough.
(Only for B versions. For
electronically protected
appliances, see the On/Off
button table).
Keep the control knob
pressed in far enough
between high and low. At
first use, this can take some
more time because of the gas
supply.
Burner does not burn evenly. Burner parts incorrectly
installed.
Burner parts dirty or damp.
Wrong type of gas used
(if bottled gas is used).
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outflow holes are open.
Check that the gas used is
suitable for the appliance.
Burner goes out after igniting. Control knob not kept pressed
in long enough.
(Only for B versions. For
electronically protected
appliances, see the On/Off
button table).
Keep the control knob
pressed in for at least
5 seconds.