Operation Manual

103
INSTALLATION INSTRUCTIONS building in
cut opening in worktop
Saw the opening in the worktop. This should be done very accurately
(building in dimensions).
If the woodtop is made of treated wood, then coat the sawn surfaces of
the top with sealing varnish, to prevent moisture causing the top to swell.
attachment points for mounting brackets
thin worktops
thick worktops
threaded hole /
screw / worktop
102
preparing the hob
Fit the elbow supplied on the appliance's gas connection.
Remove the protective foil of the sealing strip (A) and attach the sealing
strip in the groove of the aluminium profiles or the edge of the glass
plate. Do not attach the sealing strip through the corner. Instead, cut
4 pieces that fit tightly together in the corners.
1/2" ISO 228
(straight)
1/2" ISO 7/1
(conical)
sealing ring
1/2" ISO 228
(straight)
1/2" ISO 228
(straight)
sealing ring
INSTALLATION INSTRUCTIONS building in
A
only for France
Attention!
This only applies to the glass appliance.
In stainless steel appliances HG77..M
and HG97..M the sealing tape has
already been applied.
700001740000_hl_HG_4t:opm 23-10-2007 9:59 Page 102