INSTRUCTIONS FOR USE GB Postbus 1033. 6920 BA Duiven. Nederland 20 325 88-7952 Rev.
Contents Page Important Information ..................................................................................... 3 Operation .................................................................................................... 5 Care and Cleaning .......................................................................................... 6 Draining Oil .................................................................................................... 7 Technical Specifications .....................
Important Information Service and any repairs should be carried out by a service organisation approved by the supplier. Only parts supplied by the organisation stated above should be used. Please refer to the guarantee conditions. Make sure that the cable does not get pinched. The appliance is designed for ordinary household use. Using it for other purposes poses the risk of accidents.
Installation Electric installation must be performed by a certified electrician. Work done by non-specialists may cause injury to people or damage the appliance. It is not permissible to make any alterations in the electrical components of the appliance. Make sure to follow the enclosed directions for installation. ATAG is not liable if the opening in the kitchen work surface is incorrectly made and/or if the directions for installation are not or incorrectly performed.
Operation Important Advice Operating the deep-fryer This appliance has been constructed to ensure safety. However, repairs performed by non-specialists could impair the safety of the appliance. To ensure safety and prevent any damage, it is recommended to only allow people with the appropriate professional skill to repair this appliance. We recommend that your have this appliance repaired and/or checked only by a your local professional serviceman or by ATAG Service and use only original ATAG parts.
Care and Cleaning 1. Remove the safety shield from the drain cock. 2. Place a bowl under the drain cock. Make sure the bowl is large enough to hold the oil in the container. 3. Open the drain cock and let the oil run into the bowl. 4. Close the drain cock. Closed Guarantee Please refer to the accompanying guarantee booklet and guarantee card for guarantee conditions. The frying container The drain cock must closed. 1. Remove the metal filter and wash it in warm soap water. 2.
If The Appliance Does Not Work Right Draining Oil The safety plate is removed for draining oil by pushing it to the side and pulling down. Then the tap can be turned to the vertical position for draining oil. Check the fuses in the meter cupboard. Check to make sure that no circuit breakers have been tripped. If the heating thermostat has been turned off, the reset button must be pushed. Closed Important: Always replace the safety plate after draining oil.
Technical Specifications Deep-Frying Tips First set the desired temperature and wait until the oil reaches this temperature (the deep-fryer lamp automatically goes out when the set temperature is reached). Place the deep-fryer basket in the oil. Element voltage 230V Electrical connection 230V single phase positive, negative + earth Caution! Do not forget to dry off damp food before putting it in the basket (e.g. shellfish, vegetables, fruit, fish).
Mounting and Removing Fastening Plates The appliance can be placed in a 270 x 490 mm opening in a kitchen work surface. If there is not enough room for the fastening plates on the side of the deep-fryer, the screws holding them in place first have to be loosened and the plates removed. Overheating Protection If the oil in the deep-fryer pan overheats, the built-in overheating protection system will turn the appliance off. Please consult the service department to solve this problem.
Installation The appliance can be installed in any type of kitchen work surface that is 28 - 40 mm thick. Electrical Installation The built-in height required for an appliance is 245 mm. It must be possible to place at least a 4-litre bowl underneath the appliance. Fastening Unscrew the clamps until they are open sufficiently to be fastened to the kitchen work surface. Tighten the clamps securely to the work surface with a screwdriver.
