User manual

10
The appliance can be installed in any
type of kitchen work surface that is 28
- 40 mm thick.
Fastening
Unscrew the clamps until they are
open sufficiently to be fastened to the
kitchen work surface. Tighten the
clamps securely to the work surface
with a screwdriver.
Saw a rectangular opening for the
deep-fryer.
The width of this opening will always
be 490 mm. If two deep-fryers are to
be installed side by side, the opening
will be always be twice the width
minus 20 mm.
Minimum distance to wall:
150 mm.
Minimum distance to non-flammable
wall: 50 mm.
Installation of reinforcement
supports
A reinforcement support must be
installed between each deep-fryer. It is
not screwed into the kitchen work
surface but is held in place by the
frame of the appliances.
Installation
The built-in height
required for an
appliance is 245 mm.
It must be possible to
place at least a 4-litre
bowl underneath the
appliance.
11
The electrical installation is to be
performed only by a certified
electrician. Electrical installation must
be carried out according to applicable
provisions in the power current codes.
It must also meet any special
requirements set by the local power
company.
It is not permissible to make any
changes in the electrical components
of the appliance.
This appliance is supplied with an
earthed plug suitable for an earthed
socket outlet. If the socket outlet is not
earthed, a certified electrician will
have to earth the appliance according
to the applicable standards.
The manufacturer’s guarantee becomes
null and void in the event of incorrect
connection and if changes have been
made in the electrical components of
the appliance.
The appliance must be run off at
least a 10 A fuse.
Minimum type of cord:
1.0 mm² HO5 RN-F.
Electrical Installation