Quick Start Guide
Programming the timeprogram and the time/date Z
ZZ
Z
The timeprogram should be adjusted as follows. For more information, see the detailed
manual. Every flashing value can be changed by turning the rotary pushbutton and can be
selected by pushing the rotary pushbutton. Return to previous setting: press Return to
standard display: press
@< Entry into the programming level
Timeprogram
@< Entry into the timeprogramming level
1. Heating or domestic hot water:
HC=heating circuit
DHW=domestic hot water
MC1 = mixed circuit 1*
(*if available)
@<
2. Selection of timeprogram P1, P2 or P3
3 separate timeprograms can be set here.
(Only appears when P1-P3 is enabled. Request information from
your heating specialist)
@<
3. Selection of day and heating period
Setting sequence: Mo-1 cycle, Mo-2 cycle, Tu-1 cycle, Tu-2 cycle,
We-1 cycle etc. After a cycle has been entered, the next is made
available.
@<
4. Setting the beginning of the heating period
(switching-on time)
Setting range
0.00 to 24.00 h
The setting range appears in the top time bar as
a flashing segment
@<
5. Setting the end of the heating period (switching-off time)
Setting range 0.00 to 24.00 h
The switching-off time
appears in the top time bar as
a flashing segment
@<
6. Setting the desired temperature (during heating period)
Setting range 5.0 to 30 °C for heating; 10.0 to max.
DHW-setting unit
@<
7. Setting the next cycle or next day
The setting method is described above.
To return to the programming level, there are 3 possibilities:
- Return to the standard display step by step.
- Return to the standard display directly by pressing once.
- automatically after no key has been pressed for 90 s.
Detailed information on the functions described here can be found in the supplied room sensor
manual for the heating specialist.
Art. 0451003405 – 0415-20
3 sec