User`s manual

Multiple handset

Push-to-talk (PTT)

Using the telephone base:

There are a few ways to begin a PTT call to a single handset. When the

telephone base is not in use:

If you have one handset, press and hold PTT in idle mode.

-OR-

If you have more than one handset, press PTT in idle mode. Use the

dialing keys to enter a handset number (1-9 for handsets 1-9, TONE

and 0 for handset 10, TONE and 1 for handset 11 or TONE

and 2 for handset 12), or press CID or DIR to scroll to the desired

handset then press SELECT or PTT to create the push-to-talk session.

Your handset displays Connecting to HANDSET X... (HANDSET

represents the handset name, X represents the destination handset

number) for a few seconds. When the connection is made, both the

telephone base and the destination handset display Press and hold

[PTT] to talk and beep once.

Press and hold PTT. A chirp indicates your microphone is on. Speak

towards the telephone base. Your voice is broadcast to the destination

handset. While you are speaking, the handset displays PTT To HANDSET

X (X represents the destination handset number).

Release

PTT

after speaking. Both devices beep once again and the screens

show Press and hold [PTT] to talk, then you can press and hold

PTT

continue speaking or the destination handsets can respond (see Answer a

PTT call on page 75).

To end the PTT call, press CANCEL or END. The telephone base shows

Push to talk Ended for a few seconds.

-OR-

Place the handset in the telephone base or charger to end the PTT call.

The telephone base shows Push to talk Ended for a few seconds.

NOTE: After PTT is released, the PTT call remains open for a short time. If no one presses

PTT within 10 seconds, the PTT call ends automatically.

•