User`s manual

Multiple handset

Push-to-talk (PTT)

PTT to a single handset

Using a cordless handset:

There are a few ways to begin a PTT call to a single device. When the

handset is not in use:

If you have one handset, press and hold PUSH TO TALK in idle mode.

-OR-

If you have more than one handset, press PUSH TO TALK in idle mode.

Use the dialing keys to enter a handset number (1-9 for handsets 1-9,

TONE and 0 for handset 10, TONE and 1 for handset 11 or

TONE and 2 for handset 12).

-OR-

Press CID or DIR to scroll to the desired device then press SELECT or

PUSH TO TALK to create the push-to-talk session.

The handset displays Connecting to HANDSET X... (HANDSET represents

the handset name, X represents the destination handset number) or

Connecting to BASE 0... (BASE represents the base name) for a few

seconds. When the connection is made, both your handset and the

destination device display Press and hold [PTT] to talk and beep once.

Press and hold PUSH TO TALK. A chirp indicates your microphone is on.

Speak towards the handset. Your voice is broadcast to the destination

device. While you are speaking, the handset displays PTT To HANDSET X

(X represents the destination handset number) or PTT To BASE 0.

Release PUSH TO TALK after speaking. Both devices beep once again and

the screens show Press and hold [PTT] to talk, then you can press and

hold PUSH TO TALK to continue speaking or the destination handsets can

respond (see Answer a PTT call on page 75).

To end the PTT call, press OFF/CANCEL or END. The handset shows

Push to talk Ended for a few seconds.

-OR-

Place the handset in the telephone base or charger to end the PTT call. The

handset shows Push to talk Ended for a few seconds.

NOTE: After PUSH TO TALK is released, the PTT call remains open for a short time. If no one

presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.

•