User`s manual

9
Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 12 for details.
Telephone base installation
Charger installation
IMPORTANT INFORMATION:
Use only the power adapter(s) provided with this
product. To obtain a replacement, visit our website at
www.telephones.att.com or call
1 [phone]. In Canada, dial
1 [phone].
The power adapters are intended to be correctly oriented
in a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
•
•
Plug the power adapter into an electrical outlet not
controlled by a wall switch.
Plug one end of the telephone
line cord into a telephone jack
or a DSL filter.
Plug the small end of the
telephone base power adapter
into the power adapter jack on
the back of the telephone base.
Plug the large end
of the telephone
base power adapter
into a power outlet
not controlled by a
wall switch.
Route the power adapter
cord through this slot.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
If you have DSL high-speed Internet
service, a DSL filter (not included)
is required.
The DSL filter must be plugged into
the telephone wall jack.
Raise the antenna.
Route the telephone line
cord through this slot.