User manual

System Customization
AUTOMATIC PRIVACY
Press FEATURE. Dial 1.
The indicator light for Line 1 will show the current system-wide privacy status. If the light is
ON, AUTOMATIC PRIVACY is
On.
If the light is OFF, AUTOMATIC PRIVACY is
Off.
To change the privacy status, enter one of the following:
DIAL
INDICATOR LIGHT SETTING
1
OFF
Privacy Off
2
ON
Privacy On (installed)
TOLL CALL CHECK
Press FEATURE. Dial 2.
All the line indicator lights will go OFF. If you are required to dial 1 before placing toll calls,
enter 1; otherwise, enter 2. Possible choices are 1,
1 Required
(installed) and 2,
1 Not Required.
HELD CALL REMINDER
Press FEATURE. Dial 3.
All of the line indicator lights will go OFF. Enter the number of minutes for the HELD CALL
REMINDER. If you enter 0 the feature is turned off and no HELD CALL REMINDER will be
provided. You may also enter 1, 2, 3, or 4, so that the HELD CALL REMINDER will be provided
after
One, Two, Three,
and
Four Minutes.
The installed setting is
One Minute.
LINE TYPE
Press FEATURE. Dial 4.
Each line indicator light will show the current status for that line. (Line assignments are
labeled on the Administration Overlay and shown in the table on page 15). If a light is ON the
line is set as an
Outside Line.
If a light is OFF the line is set as an
Unavailable Line,
that is not
part of your system. You should set as
Unavailable,
lines that are not part of your system. If the
light is flashing an even flash, the line is set as a
PBX/Centrex Line.
To change any individual
line(s), press the line button(s) and dial 1, 2 or 3 (see table, below). You may press more than one
line button to make the change on more than one line. If you dial the number without pressing
a line button first you will hear the error tone. (The system may require up to five seconds to
complete the procedure. You will hear the confirmation tone after the procedure is completed.)
DIAL
INDICATOR LIGHT
SETTING
1
OFF
Unavailable line
2
ON
Outside Line
(installed)
3
Even Flash
PBX/Centrex Line
16 Administration Manual