Operation Manual

26
Bluetooth
Bluetooth setup
Replace an active device
If you already have 2 active devices on the device list and you want to
activate a different device, you must deactivate one of the 2 active devices.
To replace an active device:
Press MENU on the telephone base when it is not
in use.
Press CID or DIR to highlight Bluetooth, then
press SELECT .
Press CID or DIR to highlight Device list, then
press SELECT .
Press CID or DIR to highlight the device you
want to activate without a D1: or D2: prefix, then
press OPTION .
Press CID or DIR to highlight Connect, then press
SELECT . The screen displays Only 2 devices can be ready
for connection and then a list of devices for deactivation.
Press CID or DIR to highlight the device to be
deactivated, then press NEXT . The screen displays Cell
Phone A is deactivated and you hear a confirmation
tone. The screen then displays Connecting Cell Phone B
to the base...
Depending on your cell phone settings, you may
need to press a key on your cell phone to confirm
the connection. When the new device is successfully
activated and connected, the screen displays
Device connected. You hear a confirmation tone.
NOTE: When adding, removing, or replacing a Bluetooth device on the active devices list, all
connected devices are temporarily disconnected until the procedure is complete. It may take
up to 2 minutes to reconnect.
1.
2.
3.
4.
5.
6.
7.
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
DEVICE LIST
D1:Headset A
D2:Cell Phone A
Cell Phone B
BACK OPTION
DEACTIVATE
D1:Headset A
D2:Cell Phone A
BACK NEXT
Connecting
Cell Phone B
to the base...
DEVICE LIST
D1:Cell Phone B
D2:Cell Phone A
Headset A
BACK OPTION