Operation Manual

105
Answering system
Answering system settings
In the answering system setup menu, you can change the settings for call
screening, number of rings, remote access code, message alert tone and
recording time.
Call screening
The call screening feature lets you listen at the telephone
base to a caller leaving a message. While monitoring an
incoming message, you can answer the call by pressing
HOME/FLASH or /SPEAKER on the handset, or pressing
HOME on the telephone base.
To turn call screening on or off:
Using a handset or telephone base:
Press MENU in idle mode to enter the main menu.
Use CID or DIR on the handset or CID or DIR on
the telephone base to scroll to Answering sys, then
press SELECT .
Use CID or DIR on the handset, or CID or DIR on
the telephone base to scroll to Ans sys setup, then
press SELECT twice to select Call screening.
Press CID or DIR on the handset, or CID or DIR
on the telephone base to choose between On and Off,
then press SET to save. You hear a confirmation tone.
NOTE: For more information on call screening, see page 111.
1.
2.
3.
4.
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
On
Off
BACK SET
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
On
Off
BACK SET