User`s manual
63
Multiple handset use
Intercom
Using the telephone base:
Press MENU on the telephone base in idle mode.
Press CID or DIR to highlight Intercom, then
press SELECT .
The telephone base displays INTERCOM and a list
of registered handsets.
Press CID or DIR to highlight a destination
handset or All handsets, and then press SELECT .
-OR-
Press 1-9 for handset 1-9, TONE and 0 for
handset 10, TONE and 1 for handset 11, or TONE and 2 for
handset 12.
-OR-
Press TONE and then # (pound key) to call all handsets.
The telephone base displays Calling HANDSET X, or Calling all handsets.
The destination handset(s) rings and displays BASE 0 is calling.
To answer an intercom call at the destination device:
Press
HOME/FLASH or
/SPEAKER
on the destination
handset, or press
HOME
on the telephone base.
Both screens show Intercom.
To silence an intercom call:
Press OFF/CANCEL, MUTE/DELETE or SILENCE on the destination
handset, or press MUTE or SILENCE on the telephone base. The screen
displays Ringer muted for a few seconds.
To mute while on an intercom call:
Press MUTE/DELETE on the handset, or MUTE on the telephone base. The
screen displays Microphone off for a few seconds.
To end an intercom call at the destination handset:
Press OFF/CANCEL, END or place either handset back in the telephone
base or charger. Both screens display Intercom ended.
To end an intercom call at the telephone base:
Press END or CANCEL. Both screens display Intercom ended.
NOTES:
You can cancel the intercom call before it is answered by pressing CANCEL or END on
the telephone base, or pressing OFF/CANCEL or END on your originating handset.
If you are calling all devices, only the first handset to pick up can answer the intercom call.
If the destination device does not answer the intercom call within 100 seconds, is in
the directory or caller ID log, or is out of range, the initiating device displays
No answer. Try again.
1.
2.
•
–
–
–
•
•
•
•
•
•
•
•
Answering sys
Directory
Caller ID log
Intercom
BACK SELECT
INTERCOM
Handset 2
Handset 3
All handsets
BACK SELECT