User`s manual

7
Getting started
Registering the headset
To register the headset to an AT&T DECT cordless telephone
base:
Make sure the battery is properly installed
in the headset (see page 3). The ON/OFF
light flashes twice every five seconds to
indicate the headset is not registered.
Place the headset in the headset charger
and allow it to charge for at least five
minutes before beginning registration.
Remove the headset from the charger
and replace the headset back into the
charger.
On the telephone base of the cordless
phone, press and hold the HANDSET
LOCATOR button until the IN USE light
comes on (about four seconds) and release
the button.
The headset registers to the telephone
base automatically; this may take about
30 seconds to complete. The IN USE
light on the telephone base turns off.
The headset ON/OFF light turns blue on
the first headset registered. The headset
ON/OFF light turns orange on the second
headset registered. To verify registration
was successful, press the headset ON/OFF
button and check for a dial tone.
NOTE: If the registration is not successful, the ON/OFF light on the headset
flashes twice every five seconds. Reset the headset and try again. Remove the
headset from the charger and press ON/OFF. Then place the headset back into
the headset charger. Try the registration process again.
1.
2.
3.
4.